Changing a light bulb
19
IMPORTANT: BEFORE ATTEMPTING TO CHANGE
A LIGHT BULB, YOU MUST ENSURE THAT YOU
HAVE DISCONNECTED THE RANGE HOOD FROM
YOUR MAINS SUPPLY.
o Remove the grease filters (as
described on the previous page).
o Prior to touching the light bulbs
ensure that they have cooled down.
o Disconnect the light wiring point and
then, using a screwdriver, remove
the bulb holders and wiring from the
hood as shown in the diagram below.
PLEASE NOTE: The drawing above may not show the exact style of
your cooker hood.
o Fit the replacement bulbs, bulb holders and wiring in the same
manner as the originals. Reconnect the light wiring point.
IMPORTANT: It is not possible to replace the bulbs individually. It will
be necessary to obtain the bulbs, bulb holders and wiring as a
complete part.
To Next Page
Loading...
