11
Initial set-up of your oven
Selecting manual operation mode
After your appliance is connected to your mains supply for the first
time, the numbers on the timer display will flash. Before you can select
de, press the manual button (12)
supply for the first
rogramme button (12) for a couple of
e the plus and minus buttons and wait a few seconds. The
t symbol will stop flashing and the oven is ready to
manufacturing process, you should select the fan oven
a cooking function or set a temperature, you must set the appliance
into “manual operation” mode.
o To select manual operation mo
on the control panel.
Setting the time of day
After your appliance is connected to your mains supply for the first
time, you must set the time of day before you can use the oven.
When the oven is connected to your mains o
time (or after a power cut), the digits on the LED display and
the automatic cooking symbol (7) will flash.
o Press and hold down the p
seconds. The automatic cooking symbol will go out and the
digits will remain steady.
o Whilst the decimal point symbol (9) is flashing, use the plus
(11) and minus (13) buttons to set the correct time of day.
o When the correct time of day is shown on the LED display,
releas
decimal poin
use.
Before first use
o To remove any residue from the oven that may have been left
from the
function and set the thermostat to its maximum temperature
setting.
o It is perfectly normal for a smell to be produced during this
process.
o You should make sure that any windows in the room are left
open during this process.
o It is advisable for you not to remain in the room whilst the
burning off process is taking place.
To Next Page
Loading...
