12
o After the oven cavity has cooled, it should then be cleaned with
o Outer parts of the oven should be cleaned with warm soapy
o We would recommend that an appropriate stainless steel cleaner
ularly used on the stainless steel surfaces of this
o You should leave the oven on maximum setting for 30 – 40
minutes.
warm soapy water, using either a sponge or soft cloth. No
abrasive cleaners should be used.
water, using either a sponge or soft cloth. No abrasive cleaners
should be used.
and polish is reg
appliance.
imer functions T
The minute minder function
The minute minder function is a countdown time that can be set on the
flash to enter programming mode.
require.
o When the correct countdown time appears on the LED display,
ountdown time is in progress.
will sound
and the oven in use symbol will go out. The audible signal will
, the oven WILL NOT switch off at the end
oven programmer/timer. When the countdown time has finished, an
audible signal will sound.
o Press and hold down the programme button (12) until the
decimal point starts to
o Use the plus (11) and minus (13) buttons to set the countdown
time that you
o The maximum countdown time that can be set is 23 hours and
59 minutes.
release the plus and minus buttons and the countdown will start
immediately.
o The oven in use symbol (8) will appear on the LED display to
show that a c
o After a few seconds the LED display will return to showing the
time of day.
o At the end of the countdown time, an audible signal
sound for 7 minutes before switching off or you can silence it by
pressing any of the oven programmer/timer buttons.
o IMPORTANT: If the oven is in use whilst using the minute
minder function
To Next Page
Loading...
