Baumuller b maxx BM4400 User Manual (English)

Other manuals for Baumuller b maxx BM4400

Operating Handbook82 pages

Instruction104 pages

Instruction Handbook84 pages

Questions and Answers:

L
Louis RamosAug 1, 2025
What to do if the red error LED is lighting up on Baumuller Control Unit?
- A
  andrewjacksonAug 1, 2025
  If the red error LED is illuminated, it indicates an error. You can address this in several ways: * Using ProDrive (from FW 3.07), click the “Quit errors” button in the “Device manager” dialog box or on the “Device manager” page to acknowledge and address the error. * By writing access to control word (P0300), generate a rising edge in bit 7. * Configure a digital input of a DIO module via parameter P0575 for error reset. * Use the pulse enable input, assuming the drive is controlled solely via hardware inputs.
P
Paige WhiteAug 6, 2025
How to start the motor on Baumuller Control Unit if the red LED H4 isn’t lighting up and the LED H2 is green?
- H
  Heather TranAug 6, 2025
  If the motor doesn't start, but the red LED H4 is off and the LED H2 is green, check the parameterization of the b maXX 4000 using the parameter list in ProDrive. Possible errors include a torque limit set to 0 or an incorrect notch position.
K
kimvincentAug 11, 2025
What to do if no LEDs are lighting up on the front side of the Baumuller Control Unit?
- T
  Timothy NewmanAug 11, 2025
  If no LEDs are lit on the front of the device, verify the 24V supply.
L
Luis LeeAug 16, 2025
What to do if Baumuller DC Drives show Watchdog-Error?
- W
  Wesley RayAug 16, 2025
  If you encounter a Watchdog-Error with your Baumuller DC Drives, execute a restart of b maXX® 4400.
T
Todd ThompsonAug 21, 2025
What to do if an incorrect interrupt has occurred in Baumuller DC Drives?
- B
  Brandon WoodAug 21, 2025
  If an incorrect or unexpected interrupt has occurred with your Baumuller DC Drives, execute a restart of b maXX® 4400.
J
Joe BrownAug 27, 2025
What to do if NMI interrupt or bus error appear in Baumuller DC Drives?
- J
  Jacob CarterAug 27, 2025
  If you are experiencing an NMI interrupt or bus error with your Baumuller DC Drives, execute a restart of b maXX® 4400.