Warranty and After Sales protrac®
3.3 Replacing the BIOS battery
Required equipment
CR 2032 coin cell, 3 V
protrac® screwdriver (included in standard delivery)
Procedure
1. Switch off the CU.
2. Open the battery compartment and replace the coin cell.
3. Close the battery compartment.
4. Switch on the CU and set the date and time.
3.4 Cleaning the devices
Device damage due to wrong cleaning agents
Do not use any abrasive, corrosive cleaning agents or strong solvents.
Never clean electrical devices with water.
1. If required, clean the device surfaces with mild detergent and a lint-free cloth.
NOTICE! Device damage due to leaking fluids.
2. Do not allow liquids to leak into the devices.
Warranty
For warranty claims, please contact BAUR GmbH or your local BAUR representative
(http://www.baur.eu/baur-worldwide). Warranty is cancelled in case of misuse. Wear parts
are excluded from the warranty.
After Sales
For questions contact BAUR GmbH or your BAUR representative (http://www.baur.eu/baur-
worldwide).
BAUR GmbH
Raiffeisenstraße 8
6832 Sulz / Austria
service@baur.at
www.baur.eu
4 WARRANTY AND AFTER SALES
To Next Page
Loading...
