– 17 –
Setup Hints
• During Rest Period, the unit does not heat, cool or circulate air; this allows the dough to rest.
• During Recovery Time, the unit slowly heats up and adds humidity, bringing the unit to the preset
temperature and humidity and into the proof stage of the automatic retard/proof process.
SELECT PROOFER MODEL VIA BOOTLOADER
The proofer model is set at the factory. However, if the proofer model needs to be changed this procedure
shall be followed.
1. Turn o the Proofer with the ON/OFF button.
2. Hold these three buttons, in this order for 5 seconds.
• HUMIDITY DOWN ARROW
• TEMPERATURE UP ARROW
• ON/OFF Button.
3. Keep holding the three buttons until "conF" is shown in the Temperature display (Fig. 23).
Fig. 23
4. The current proofer conguration value will be displayed in the HUMIDITY display. 1, 2 or 3
5. Pressing the HUMIDITY UP ARROW will cycle through the congurations, 1, 2 or 3
• Cong 1: Proofer (PW)
• Cong 2: Retarder/Proofer (RPW)
• Cong 3: Dehumidifying Proofer (DPC1S)
6. The conguration is saved by pressing the ON/OFF button.
7. The TEMP and HUMIDITY display LEDs will ash on and o for two seconds to indicate that the
new conguration has been saved.
8. The proofer control board will reboot with the new conguration.
NOTE: If the application rmware is corrupt or missing, the unit will enter the bootloader automatically.
This will happen even if you do select a proofer model, it will still return to the bootloader where you are
required to load the rmware. To correct this error, update the proofer rmware.
MANUAL PROOF ON
SELECT RECIPE >
To Next Page
Loading...
Need help?
General
