Baxtran BR16 - Hold Function

55
ENUSER’S MANUAL BR16
5.Thedisplaywillshowthemessage“000.00h”(Superiorlimit=Hi)
6.Usethekeys and tomovethecursorandthekey to choose the desired number.
Note:Ifyouneedtochangeormodifythelastdigityoucanplacethecursoronittodoit.
7.Pressthekey to confirm.
8.Thedisplaywillshowthevalue.
A B C
0 0 0
(configuration of the alarm)
DISPLAY VALUE ESTABILITY
A 0 Thereisnoneedtostabilizethealarmtomakeitring
1 Thealarmmustbestabilizedtoring
B 0 Always0
C 0 Alarmswitchedoff
1 ThealarmringifitisplaceonthebandOK
(betweenthelimits Lo and Hi)
LO OK HI
2 Thealarmringsifitissituatedbelowthe
inferior limit Lo or above the superior limit
Hi
LO OK HI
9.Pressthekeys and tomovethecursorandthekey to choose the desired number..
10.Pressthekey to confirm.
TheindicationsonscreenLo,Ok,Hiwillappearonscreendependingontheweight.
8.3 AUTO SWITCH OFF|
UF-3
MODES:
• AoFF 00–Autoswitchoffdeactivated
• AoFF 01–Autoswitchoffactivatedinaminute.Thescaleisgoingtoswitchoffautomaticallyafter1minuteofnotbeingused.
• Youcanconfigurethevaluewishedfrom1to99minutes.
1.Pressthekey to have an access to the parameter.
2.Pressthekeys and tomovethecursorandthekey to choose the desired number.
3.Pressthekey
to confirm.
8.4 DISPLAY BACKLIGHTING |
UF-4
MODES:
• A: Automatic.
• ON: Illumination Activated.
• OFF: Illumination Deactivated.
1.Pressthekey to have an access to the parameter.
2.Pressthekey to select the desired mode.
3.Pressthekey to confirm.
8.5 HOLD FUNCTION |
UF-5
(Oncetheobjectisretiredfromtheplate,thedisplaymaintainstheweightfixedduringsomeseconds.Thisfunctionisveryusefulfortheweighingof
animals)