Baxtran BR16 - Weight Calibration LF 1; Configuration Settings LF 2; Internal Counting Display; Possible Parameter Values

61
ENUSER’S MANUAL BR16
CALIBRATION OF THE WEIGHT LF 1
DISPLAY DESCRIPTION AND SEQUENCE OF USE
Thecalibrationcanbedonewithanyweight,buttheweightcanotbeinferiorto1/100ofthemaxi-
mumcapacityanditmustalsoneverbeexceeded.
•Pressthekey tostartthecalibrationofzero(press Toexitthecalibrationandgobackto
themenuLF1)
LF 1
CAL Z
150.00 kg
•Use , and ,0 ~ 9 and then press tointroducetheweightwithwhichthe
calibrationwillbedone.(pressthekey toexitthecalibrationandgobacktothemenuLF1)
150.00 kg
•Placetherequiredweightonthescaleasitisindicatedinthedisplay.
150.00 kg
•Onceeverythingissteady,pressthekey tocalibrateit(pressthekeyESCtoexitthecalibration
andgobacktothemenuLF1).
THECALIBRATIONISGOINGTOFINISHANDTHESCALEWILLGOVACKTOTHEWEIGHINGMODEAUTOMATICALLY.
CONFIGURATION LF 2
DISPLAY DESCRIPTION AND SEQUENCE OF USE
FIRST STEP
•DISPLAYOFTHEINTERNALCOUNTING
262144
SECOND STEP
•POSSIBLEVALUESOFTHEPARAMETERS
A:Metricsystem 0:NO 1: kg 2:T 3:g
1 0 0 0 0 1
B:Americansystem 0:NO 1: lb 2:lboz
C: other unities 0:NO 1:TWkg 2:HKkg 3:VISS
D:PCS 0:OFF 1:ON
A B C D E F
E: double range 0:OFF 1: multi interval 2:multi range
F:unitsofcalibration
1:use metric
unities
2:use american unities
lbozcannotbeselectedasunitiesofcalibration.
Thescalewon’tletuscontinueuptothenextstepifthereisamistakeduringtheprogramming.
THIRD STEP
•Use , and ,0 ~ 9 and then press tointroduceTHEMAXIMUMCAPACITY,
consideringthenumberofdecimalzerostobeused.Ex.150.00kg=introduce15000ifthenselected
as decimal
d0.00
000000kg
FOURTH STEP
•UsetheKeys , tochangethepositionoftheDECIMALPOINT.
dP 0.0
d 0.00 d 0.000 d 0.0000 0.00000
FIFTH STEP
•Use toselecttheDIVISION:
diV 01, diV 02, diV 05, diV10, diV 20, diV 50
diV 01