BBQ Guru UltraQ - Contact BBQ GURU; Food Temperature Accuracy Check; Probe Not Detected; Company Information

EN | UltraQ | Operating instructions EN | UltraQ | Operating instructions
13 CONTACT BBQ GURU
THE FOOD TEMPERATURE IS NOT RIGHT.
It is normal for different brands of thermometers to
vary in temperature measurement, but they should
usually be within a few degrees. Place your thermo-
meter in boiling water to check it for accuracy. If the
food probe reads hotter than another food probe,
check that the probe is fully inserted into the food at
the thickest part. If too much of the probe is exposed,
the probe will read hot. If the food has a bone in it,
make sure the probe is not touching any part of
the bone.
If the display shows „---“, rst check that the probe is
pushed fully into the socket. If this is still the case,
the probe may be broken. If the probe wire shows
small, reddish bumps on the outside of the stain-
less steel mesh, the silicone insulation has melted
because the probe was exposed to direct ame or
excessive temperatures.
The BBQ Guru
powered by Monolith Grill GmbH
Frida-Schröer-Straße 56
49076 Osnabrück
0541 / 2019 640
info@bbq-guru.eu
bbq-guru.eu
ENVIRONMENTAL
CONDITIONS :
Temperature:
5°C to 40°C / 41°F to 104°F
Relative humidity:
80%,
Non condensing height:
2000 Metres / 1,24 Miles
Input assessment:
IP53
Accuracy:
at 1,2 °C (5°C to 40 °C environment), at 2,8 °C (40
°C to 180 °C / 104 °F to 473 °F environment)
Controller input supply:
12V DC, 3,5A, 42W
Conguration:
Wand-Plug-in
Wi-Fi Modul:
Includes transmitter module FCC ID:
2ADHKATWINC1500 and 2AA9B04 with radio
regulatory certication for USA (FCC), Canada (IC),
Europe (ETSI), Korea(KC) and Japan (ARIB) 2.4
GHz, IEEE Std 802.11b/ b, g, n™ and WiFi® certied
(WFA ID: WFA16869).
The Wi-Fi components in this product are certied
under Wi-Fi 802.11withWPA2™ and WPA™ System
Interoperability ASD Model Test Plan with Test Engine
for IEEE 802.11b, n and g devices). Other 2.4 GHz
devices, such as cordless phones and wireless
networked devices, may cause interference with the
UltraQ and prevent a reliable connection. It is the
customer‘s responsibility to diagnose the cause of
the interference and determine which devices need to
be turned off or removed from the installation.