User’s Manual
51
2.2.1.3 IDE Channel 0/1/2/3/4/5 Master / Slave / SATA1 / SATA2
z IDE HDD Auto-Detection
[Press Enter]
to select this
option for automatic device detection.
z IDE Device Setup
[Auto]: Automatically detects IDE devices during POST
[None]: Select this when no IDE device is used. The system will skip the auto-detection
setup to make system start up faster.
[Manual]: User can manually input the correct settings.
9 Access Mode: The options are CHS/LBA/Large/Auto
9 Capacity: Capacity of currently installed hard disk
9 Cylinder: Number of cylinders
9 Head: Number of heads
9 Precomp: Write precomp
9 Landing Zone: Landing zone
9 Sector: Number of sectors
2.2.1.4 Halt On
Set the system to halt on errors according to the system functions specified in each option.
Configuration options: [All Errors] [No Errors] [All, But Keyboard] [All, But Diskette] [All, But
Disk/Key]
2.2.1.5 Memory
This category displays base memory, extended memory, and total memory detected during
POST (Power On Self Test).
To Next Page
Loading...
