To Next PageTo Next PageHow to fix BEA IXIO-DT1 Security Sensors when the sensor does not respond to the remote control?
If your BEA Security Sensors are not responding to the remote control, the most likely cause is dead batteries. Replace the batteries in the remote control.
What to do if BEA IXIO-DT1 Security Sensors encounter a memory problem?
If your BEA Security Sensor encounters a memory problem, try cutting and restoring the power supply. If the orange LED lights up again after doing so, it indicates that the sensor needs to be replaced.
What to do if my BEA IXIO-DT1 see the door during the assisted setup?
If your BEA Security Sensor is showing the door during the assisted setup, try these steps: * Move the IR-curtains away from the door. * Install the sensor as close to the door as possible. * Use a bracket accessory if necessary. * Launch a new assisted setup.
Why is my BEA Security Sensors vibrating?
If your BEA Security Sensor is vibrating, check to ensure it is firmly fastened. Also, check the position of the cable and cover to make sure they are not contributing to the vibration.
What does it mean if my BEA Security Sensors signals an internal fault?
If your BEA Security Sensor signals an internal fault, the suggested solution is to replace the sensor.
What to do if BEA Security Sensors receives not enough IR-energy?
If your BEA Security Sensor is not receiving enough IR-energy, you can try the following: * Decrease the angle of the IR-curtains. * Increase the IR-immunity filter (values >2.8 m). * Deactivate 1 curtain. * Slightly increase the angle of the IR-curtains.
What causes BEA IXIO-DT1 Security Sensors to receive too much IR-energy?
If your BEA Security Sensor is receiving too much IR-energy, eliminate the source of the disturbance. This could be lamps, issues with the rain cover, or the door controller housing not being properly grounded.
What to do if the power supply is too low or too high for my BEA IXIO-DT1?
If the power supply to your BEA Security Sensor is too low or too high, check the power supply in the diagnostics menu of the LCD and inspect the wiring.
How to stop BEA IXIO-DT1 from detecting the door or other moving objects?
If your BEA Security Sensor is detecting the door or other moving objects, initiate an assisted setup and adjust the IR angle to correct this.
What if the SDC setting does not match with the real product position in BEA IXIO-DT1 Security Sensors?
If the SDC setting does not match the actual product position for your BEA Security Sensor, lock the SDC position setting.
General| Technology | Microwave |
|---|---|
| Mounting Height | Up to 13 ft (4 m) |
| Current Consumption | 35 mA (relay energized) |
| Operating Temperature | -4° to +131°F (-20° to +55°C) |
| Housing Material | ABS |
| Dimensions | 4.72 in (H) x 3.15 in (W) x 1.97 in (D) / 120 mm (H) x 80 mm (W) x 50 mm (D) |
| Tamper Switch | Yes |
| Output | Relay |
| Humidity | 0 to 95% non-condensing |
| Coverage Pattern | Adjustable |
| Alarm Output | Relay (NO/NC) |
| Supply Voltage | 12 to 24 VAC/VDC |
| Operating Voltage | 12 to 24 VAC/VDC |
