To Next PageTo Next PageWhat to do if no Floppy Disk after BEA LZR-MICROSCAN T setup?
If you don't see a 'Floppy Disk' indication after setting up your BEA Security Sensors, it could mean that the learn process has failed. Try performing a new learn. Also, verify that the Home Switch is functioning properly.
What to do if no “CLEAR AREA” during BEA LZR-MICROSCAN T Security Sensors setup?
If you don't see a 'CLEAR AREA' message during the setup of your BEA Security Sensors, it's possible that the sensors haven't been discovered. Make sure the sensor harness connection is secure.
What does 'Cap LCD screen' mean for BEA Security Sensors?
If the BEA Security Sensors display shows 'Cap LCD screen', it indicates that a learn procedure is required. Perform a re-learn to resolve this issue.
What to do if BEA LZR-MICROSCAN T Security Sensors Hub shows environment error?
If your BEA Security Sensors hub is showing an environment error, it could be due to several reasons. Verify the power supply voltage, ensuring it is powered by a BEA power supply. Also, the environment may be too cold or hot for the hub to operate correctly. Check that the door control is capable of monitoring and that the sensor monitoring wires are properly connected to the door control. Finally, verify that monitoring is active in the sensor settings for each door control.
What to do if BEA LZR-MICROSCAN T Security Sensors door never reaches “Hold Open” or “Off” states?
If the BEA Security Sensors door never reaches the 'Hold Open' or 'Off' states, ensure that you are using an On/Off/Hold Open switch. Wire your existing switch to the jumper, or plug a BEA On/Off/Hold Open Switch into the hub.
What does orange flashing LED on BEA Security Sensors mean?
An orange flashing LED on your BEA Security Sensor indicates an error. Possible causes include: * The sensor is mounted too high or adjusted too close to the door. * The door did not fully open during the learning phase (EDPS). * The number of doors configured is incorrect (BUS config). * The sensor is obstructed by an object (boundary). * There is a loose or broken sensor harness (lost message).
What to do if BEA LZR-MICROSCAN T Security Sensors door(s) keep recycling (ghosting)?
If your BEA Security Sensors door(s) keep recycling or 'ghosting', it could be due to the approach-side sensors detecting motion. Try adjusting the Activation Distance and/or motion sensor settings of the approach-side sensors. Another cause might be the Home Switch not properly registering when the door is closed. In this case, adjust the Home Switch and check its wiring.
What to do if BEA Security Sensors door(s) will not open/close?
If the BEA Security Sensors door(s) will not open or close, first, ensure the door control is operational independently. Then, check that all connections are secure, including sensors and the On/Off/Hold Open switch. Verify that the 'Knowing Act' feature is disabled unless you are using compatible devices. Also, confirm the wiring from the hub to the door control is correct, and verify the monitoring settings and wiring.
What to do if BEA LZR-MICROSCAN T Security Sensors encounter an internal hardware error?
General| Brand | BEA |
|---|---|
| Model | LZR-MICROSCAN T |
| Category | Security Sensors |
| Language | English |
