3
SETUP
You can power the AK280 either by batteries or by power adaptor.
Before you switch the AK280 on, turn down the volume and any
connected audio equipment rst.
Using Batteries
The AK280 needs 6 pieces of AA (NO.5) or equivalent alkaline
batteries for power supply.
1. Open the battery compartment cover located on the bottom
of the AK280.
2. Insert the batteries, carefully follow the polarity markings on
the cabinet.
3. Replace the compartment cover, making sure that it locks
rmly in place.
Caution:
Do not mix used and new batteries.
Always use batteries of the same type.
Always remove the batteries from the AK280 when it is not used
for an extended period of time.
Using the Power Adapter
1. Connect the adaptor to the power supply jack of the AK280.
2. Plug the adaptor into an AC outlet.
3. Press the POWER SWITCH. The LCD screen will light up. This
indicates the AK280 is powered on.
4. If you are ready to turn o the AK280, press the POWER
SWITCH again.
Note:
The piano will automatically shutdown to preserve power if not
used for 30 minutes.
When the keyboard is not in use or is being used during a
thunderstorm, please disconnect the power for safety purposes.
This section contains information about setting up the Ak280 and preparing to play. Please go through this section
carefully before turning the power on.
A music stand is supplied with the AK280. You can easily attach it
by inserting it into the slots at the rear of the panel.
POWER SUPPLY
ATTACHING A MUSIC STAND
To Next Page
Loading...