2.4 DELETE A CHASE
1. Select the chase you wish to delete.
2. Press and hold down the Auto/Del button. Tap the Chase button while holding down the
Auto/Del button, all LEDs and the Segment Display will flash three times briefly indicating
this chase has been deleted.
2.5 DELETE ALL CHASES
1. With the power off, press and hold down the Auto/Del and Bank Down buttons at the
same time.
2. Apply the power again.
3.0 ASSIGN/REVERSE DMX CHANNEL
3.1 ASSIGN DMX CHANNEL
1. Program enable.
2. Press the Fine and Mode buttons at a time, the Assign LED light up indicating Assign mode is
active.
3. Use Bank Up/Down button to change between the Pan and Tilt, the corresponding LED lights
indicating this selection,
4. Tap the Tap/Display button to change between 8CH. And 16Ch. Mode, the LCD Reads
5. Tap the fixture button to select the fixture.
6. Tap the page select button to select page A or page B.
To Next Page
Loading...
Need help?
General
