P. [Unit] Setting
range
Description Ex works
5A4
0..1
Direction FE10 (BDC-XXX M1)
For setting the direction with two-way traffic control for this input.
0: Inside
1: Outside
This function is only possible in combination with BDC‑XXX M1 when setting
P.800:1 and P.892:1.
1
5B0
0..15
FE11 (radio channel 1) function
Selection of the input function for input FE11 (radio channel 1)
This function is only possible when setting P.802:1.
14
5B1 FE11 (radio channel 1) parameter
Selection of the input profile for input FE11 (parameter depends on input function
configured)
This function is only possible when setting P.802:1.
02
5B4
0..1
FE11 (radio channel 1) direction
For setting the direction with two-way traffic control for this input.
0: Inside
1: Outside
This function is only possible when setting P.802:1 and P.892:1.
1
5C0
0..15
Function FE12 (radio channel 2)
Selection of the input function for input FE12 (radio channel 2)
This function is only possible when setting P.802:1.
11
5C1 FE12 (radio channel 2) profile
Selection of the input profile for input FE12 (profile depends on input function con-
figured)
This function is only possible when setting P.802:1.
02
5C4
0..1
Direction FE12 (radio channel 2)
For setting the direction with two-way traffic control for this input.
0: Inside
1: Outside
This function is only possible when setting P.802:1 and P.892:1.
1
5D0
0..15
Function FE13 (radio channel 3)
Selection of the input function for input FE13 (radio channel 3)
This function is only possible when setting P.802:1.
12
5D1 Profile FE13 (radio channel 3)
Selection of the input profile for input FE13 (profile depends on input function con-
figured)
This function is only possible when setting P.802:1.
00
5D4
0..1
Direction FE13 (radio channel 3)
For setting the direction with two-way traffic control for this input.
0: Inside
1: Outside
This function is only possible when setting P.802:1 and P.892:1.
0
5E0
0..15
Function FE14 (radio channel 4)
Selection of the input function for input FE14 (radio channel 4)
This function is only possible when setting P.802:1.
13
41
To Next Page
Loading...
