Becker S20 MLS - Safety Edge; DIP Switch Settings for Safety Edges


Assembly and Operating Instructions
Safety edge
S20 MLS 

 
 
 


         8
9   

S20 MLS 

ΩΩ
6
7867
8


Caution!
When using a pneumatic safety edge, the DIP switch 2 must always
be set to the ON position, as the functioning of the pneumatic safety
edge cannot otherwise be properly monitored. When delivered, safe-
ty devices may be bridged. Before initial use, always check that no
non-permissible bridging exists.
            
S20 MLS 
S20 MLS
Type of safety edge DIP 1 DIP 2 DIP 3
   
   
   
   
   