Becker S55 - Overview.of.functions; Installing.the.control.unit


Operating Instructions
Overview of functions


∅


Attention
When removing housing knockouts in order to t more cable glands, take care not to damage any compo-
nents on the control boards or the housing itself. Only t sealing cable glands which ensure the housing
has the correct degree of protection.
When retting the cover, ensure that the seal and the seal groove are clean and that the cover is mounted
properly.
Tighten up the housing cover screws carefully. Only then will the IP 54 degree of housing protection re-
main intact.
Installing the control unit




Function ELS Professional Card
 


 

 




 

 

 








 

 

 

 












 
