Need help?Do you have a question about the Beckman Coulter AutoMate 1250 and is the answer not in the manual?
General| Sample Types | Serum, plasma, urine |
|---|---|
| Module Options | Decapper, Aliquoter |
| Power Requirements | 240 VAC, 50/60 Hz |
| Type | Automated Sample Preparation System |
| Reagent Capacity | Up to 60 onboard reagents |
| Interface | RS-232, Ethernet |
| Barcode Reading | 1D and 2D barcode reading |
| Dimensions | Approximately 72" W x 36" D x 60" H |
| Weight | Approximately 1200 lbs |
Explains hazard alerts, warnings, cautions, important notes, and tips for safe operation.
Details safety symbols and their meanings, including protective measures.
Provides guidance on avoiding power failures, restarts, and equipment damage.
Overview of the system's user interface and its functional organization.
Step-by-step instructions for powering on and initializing the AutoMate system.
Details user actions and interventions during sample distribution processes.
Procedures for operating and maintaining the aliquot module, including tip replacement.
Step-by-step procedure for safely shutting down and preparing the system for maintenance.
Guidelines for cleaning the system and recommended disinfectants.
Periodic maintenance tasks categorized by frequency and system component.
Procedures for cleaning the recapper module, applicator, and O-rings.
Guides users through common recapper errors, their causes, and solutions.
Steps to take after a laboratory-wide power failure affecting the AutoMate system.
Procedure for resolving AutoMate PC freezes and software crashes.
Addresses common errors and issues related to the aliquot module's operation.
To Next Page