Troubleshooting
Condition Possible Cause Solution
Flame goes out while in use
Empty Gas cylinder. Replace cylinder.
Air mixed in hoses.
Re-ignite and allow operating for
a short while, till clears out
Blockage Seek professional assistance.
Ignition failure
gas cylinder valve close
Turn off knob button, then open
the cylinder valve
Air mixed in the hoses
Re-ignite and allow operating for
a short while, till clears out.
Rubber hose wrapped, deformed
or pinched
Release hose, ensure not
damaged or leaking
Spark Escaping
Ensure the spark probe is in
place, not deform ed, clean.
No Spark Seek professional assistance.
Foul smell of gas
Damage to hose
Turn cylinder valve off, replace
hose.
Leakage
Leak-test, and tighten where
required.
If leakage can’t be rectified,
cease using appliance, and seek
professional assistance
Burner went off
Shut off valves, wait for 5
minutes and reignite
Incorrect combustion Seek professional assistance
Flame appear to separate off the
burner or flame burns with noise
blockage of burner Ports
Clean the burner thoroughly.
If problem persists, Seek
professional assistance
Yellow Tipping in Flame
Air/ Gas mixture screw in burner
incorrect
Try to open screw to remove
yellow. If not changing, seek
professional assistance
Spare Parts:
1100series Ins_Au_V0
To Previous Page
Loading...
