Assem bly I nstructions
General
This barbecue can be mounted onto a m obile trolley.
The Trolley is packed in a separate carton. Please refer to the Trolley instruction booklet for assembly of
the trolley, and barbecue mounting.
Once the barbecue had been properly installed, please check the following:
1. Hood is fully engaged into the four slots in the barbecue’s body.
2. All burners are in place correctly and secure
by an ‘R’ clip:
3. Vaporizers are installed individually on the steps above burners, but under the Grill (not required
under the Plate). They are inserted into the positioning slots like this:
4. Cooking surfaces (Grill and Plate) are clean, and installed over the burners and vaporizers.
Using Your Barbecue:
Before you light the Barbecue
Perform the following checks:
• Make sure all connections are tight, and leak-tested. Gas regulators fitted with a hand-tightened wheel
must be checked to ensure they are secured.
• Check that all control knobs are in the ‘Off’ position, and that gas supply is turned off.
• Ensure that the Hood on the barbecue, and the Lid on the side-burner are open. If lids are closed there
is a risk of gas accumulating inside, and creating a dangerous situation.
• The hose and regulator supplied with this barbecue must be used at all times whilst operating this
barbecue. Inspect the hose and regulator regularly for cracks or any sign of damage. If there is
excessive abrasion or wear, replace only with a genuine BeefEater regulator.
• The bottom panel of the Barbecue is clean and free of any fat or other food residue.
To Next Page
Loading...
