EasyManua.ls Logo

Beem Classico - Device Operation Details; Inserting and Removing Portafilter; Switching the Device On; Programming Drink Quantities

Beem Classico
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN 32
Inserting / Removing the Porta lter
1. Insert the porta lter (12) into the device so that the two locking lugs on the porta lter
sit in the recesses which are provided for them on the device. Twist the porta lter
anticlockwise to secure it (Picture C).
2. To remove the porta lter from the device, turn it clockwise a little and then pull it out
downwards.
3. To remove the used coffee powder, tap the porta lter gently against an edge (e.g. of
a dustbin, a bowl or similar object) so that the compressed coffee powder can be
released. Dispose of the coffee powder in an environmentally friendly manner.
Cup Warmer
The device features a cup warmer (15) which is heated automatically as soon as the
device is switched on. Turn over the cups which are to be heated and place them on the
cup warmer for approx. 5 10 minutes (Picture D).
Switch On
When the device is rst switched on, the red control lamp (18) ashes and you will hear
two beeps several times in succession to indicate that the device is not yet ready for
operation.
1. Place a cup or a small vessel under the coffee outlet (14).
2. Press any button. The device draws water and lls the water system with liquid. A
small amount of water always runs through here. The device is now ready for opera-
tion.
3. Press the button
(16) to switch on the device and preheat the water. The control
panel ashes during the heating process.
Programming Quantities
Both the quantity of espresso and the quantity of milk can be programmed for each
function. This allows you to set the perfect quantity of espresso and milk to suit your own
taste.
The set quantities are saved until a new quantity is set.
Espresso, Double Espresso, Milk Froth
1. Fill the device as if a speciality coffee is to be prepared (see the “Preparation” chap-
te
r).
2. If necessary, fold out the milk nozzle (8) using the lever (7) (Picture E).
3. Place a suitable cup below the coffee outlet (14) or the milk nozzle.
4. Select the function that is to be reprogrammed. Press the appropriate button (a beep
sounds) and keep it held down (another beep sounds).
03428_DE-EN-FR-NL_A5_V3.indb 3203428_DE-EN-FR-NL_A5_V3.indb 32 12.01.2018 11:24:4412.01.2018 11:24:44

Related product manuals