Beem Classico - Coffee Preparation; Preparing Cappuccino and Latte Macchiato; Preparing Milk Froth

35 EN
A beep sounds, the brewing process starts and the chosen button fl ashes. Hot water
is poured over the coffee powder to brew it.
At the end of the brewing process, a beep sounds, the control panel is fully lit up again
and the device automatically switches to stand-by mode.
Cappuccino / Latte Macchiato
The perfect amount of espresso and milk to suit your own taste can be program-
med in the device (see the “Handling and Operation” chapter | “Programming
Quantities”)
1. Fill the water tank (2) (see the “Handling and Operation” chapter | “Filling the Water
Tank”).
2. Fill the milk tank (see the “Handling and Operation” chapter | “Filling the Milk Tank”).
3. Insert the fi lter you want
into the portafi lter (12) (see the “Handling and Operation”
chapter | “Inserting / Removing the Filter in the Portafi lter”).
4. Fill the fi lter with coffee powder (see the “Handling and Operation” chapter | “Filling
the Filter With Coffee Powder”).
5. Insert the portafi lter into the device (see the “Handling and Operation” chapter |
“Inserting / Removing the Portafi lter”).
6. Fold out the milk nozzle (8) using the lever (7) (Picture E).
7. If necessary, select the setting you want using the dial for the milk froth (5) (see the
“Handling and Operation” chapter | “Setting the Milk Froth Quantity”).
8. Press the button (16) to switch on the device and preheat the water. The control
panel fl ashes during the heating process.
9. Place a suitable cup below the coffee outlet (14) and the milk nozzle.
10. As soon as the device has heated up, the control panel stops fl ashing. Press the
button
(23) for cappuccino or the button (19) for latte macchiato. A beep
sounds, the brewing process starts and the chosen button fl ashes. Milk is heated
with steam and frothed up. Hot water is poured over the coffee powder to brew it.
At the end of the brewing process, a beep sounds, the control panel is fully lit up again
a
nd the device automatically switches to stand-by mode.
Milk Froth
The perfect amount of milk to suit your own taste can be programmed in the de-
vice (see the “Handling and Operation” chapter | “Programming Quantities”)
1. Fill the water tank (2) (see the “Handling and Operation” chapter | “Filling the Water
Tank”).
2. Fill the milk tank (see the “Handling and Operation” chapter | “Filling the Milk Tank”).
03428_DE-EN-FR-NL_A5_V3.indb 3503428_DE-EN-FR-NL_A5_V3.indb 35 12.01.2018 11:24:4512.01.2018 11:24:45