EN 40
Problem Possible cause Fix
The red indicator light
lights up constantly.
The device is defective.
Contact the customer service
department via our website:
www.beem.de
The yellow indicator
light (22) fl ashes.
The device is furred up.
Descale the device (see the
“Cleaning and Care” chapter |
“Descaling”).
The espresso runs
very slowly into the
cup.
The coffee outlet (14) or the
fi lter is clogged.
Clean the portafi lter (12) and
the fi lter.
The device is furred up.
Descale the device (see the
“Cleaning and Care” chapter |
“Descaling”).
The espresso is too
weak.
There is not enough coffee
powder in the fi lter.
Pour the right quantity of
coffee powder into the
respective fi lter (see the
“
Handling and Operation”
chapter | “Filling the Filter With
Coffee Powder”).
The set espresso quantity is
t
oo much for the quantity of
coffee powder in the fi lter.
The perfect amount of
espresso to suit your own
taste can be programmed in
the device (see the “Handling
and Operation” chapter |
“Programming Quantities”).
A large amount of
steam is produced in
the brewing process.
The device is furred up.
Descale the device (see the
“Cleaning and Care” chapter |
“Descaling”).
Cappuccino, latte macchiato
or milk froth has been
selected, but there is no milk
in the milk tank.
Wait until the programme has
run through. Allow the device
to cool down a little. Remove
the milk tank from the device
and fi ll it
(see the “Handling
and Operation” chapter |
“Filling the Milk Tank”).
Then run the programme
again.
03428_DE-EN-FR-NL_A5_V3.indb 4003428_DE-EN-FR-NL_A5_V3.indb 40 12.01.2018 11:24:4612.01.2018 11:24:46
To Next Page
Loading...
