All changes the Random command makes must be manually saved to persist after a power
cycle. (See Chapter 4.3)
14 Voltage Control
Each Oneiroi knob (except the modulation knobs) has a dedicated control to set the amount of
CV it receives. To access the controls, enter the CV mapping mode by pressing the SHIFT and
the CV AMT buttons together. Then, adjust the knob you want to be affected by the CV from 0%
to 100% (the default is 100% for all primary parameters).
In addition, the 4 CVs of the effects, which are initially assigned to the main parameters, can
also be similarly assigned to secondary parameters.
CV routing can be reset back to default (100% for all primary parameters) by simultaneously
pressing the RECORD and RANDOM buttons.
All changes made must be manually saved to persist after a power cycle. (See Chapter 4.3)
15 Startup Settings
The startup settings configure how Oneiroi knobs work and their ranges while attenuating
modulation and external CV.
These settings are stored in non-volatile memory so they stay the same after powering off the
module.
To enter the star tup settings mode, hold down both RECORD and RANDOM buttons
while turning on the module, then release them once the two catch-up LEDs have turned
on. The MOD AMT Button will become green to indicate you are at the startup Settings.
15.1 Knobs behavior Modes.
Due to the multi-layered nature of Oneiroi, you will find many moments where the physical
position of the knob does not match the parameter’s value.
This issue is addressed in two different ways:
● Jump Mode. When a knob is moved, the value is immediately set to the current position
of the knob. This is the default mode.
● Catch Mode. (AKA Pickup, Snap, Soft Takeover or Pass-Thru) When you adjust a knob,
the module waits for you to match the parameter 's actual value before making any
changes. In this mode, the Catch LEDs will guide you left or right until you reach the
physical catch point. They will also blink together while catching it.
To Next Page
Loading...