They also indicate key points of some parameters like pitch and Looper speed
43. Randomization amount
44. Randomization target
45. Randomize button
46. Dry/Wet faders: Manual controls for the Dry/Wet of the four FX processors. With their
equivalent CV input jacks used (see number 4), they become attenuators of the incoming
CV
5 Structure
The Oneiroi audio engine consists of two main components: sources and effects.
The available sources are:
● Sine oscillator
● Supersaw oscillator/wavetable oscillator (mutually exclusive)
● Looper
● External input (recorded when in PRE mode)
● Resample output (only for recording in POST mode)
The sine oscillator and the supersaw-wavetable combo share the same pitch control
but have two separate volume controls.
External input and resample output are mutually exclusive when recording, but the
external input has volume control and can be sent directly to the effects.
The effects units are:
● Filter
● Resonator
● Echo
● Ambience
The effects are connected in series. Each fader controls the dry/wet ratio of a specific effect in
the signal path. When a fader is at its lowest position, the signal passes on to the next unit
unaffected.
The filter is the only unit that can be moved to any position along the effects chain.
To Next Page
Loading...