While in the startup settings page (RECORD+RANDOM at startup)
,The SHIFT button allows you to toggle between the two knob behaviors: LED on is Catch Mode,
and LED off is Jump Mode.
15.2 Modulation Amount range.
The level controls of the LFO destinations and the CV inputs can work in two ways:
● Attenuator Mode. This is unipolar behavior, where you get the minimum level at the
potentiometer's leftmost position and the maximum at the rightmost position. This is the
default behavior.
● Attenuverter Mode. This is bipolar behavior, where you get the minimum level at the
center position, the maximum level at the rightmost position, and the maximum level but
with inverted polarity at the leftmost position.
The RECORD button allows toggle modulation amounts between Attenuverter Mode (LED
on) and Attenuator Mode (LED off), while the RANDOM button does the same for the CV
amounts.
15.3 CV Control Amount range.
Similarly to the Modulation destinations, the CV level controls of the CV inputs can work in
Attenuator or Attenuverter Mode.
While in the startup setting page, the RANDOM button allows you to toggle CV amounts
between Attenuverter Mode (LED on) and Attenuator Mode (LED off).
16 Specs
SIZE: 30 HP, 25mm deep
Power requirements:
+12V:200mA
-12V: 80mA
+5V:0mA
(10-pin to 16-pin cable)
To Next Page
Loading...