Bego Nautilus T User Manual

26
86105 BA-en/00
English ⋅ Nautilus
®
CC plus ⋅ Nautilus
®
T
en
Insert both crucible halves.
(*): Uneven crucible tips that do not close can be
smoothed out by pulling them over fine sandpaper
(grit size ≥ 80).
For special alloys, sprinkle a pinch of BEGO
Auromelt HF melting powder on the alloy (see
program table on page 34).
Melting powder made by other manufacturers may
impair the casting result!
NOTICE
Observe minimum and maximum quantities!
WARNING
ATTENTION (check before every
casting process)
• The handles must lie on the base
surface.
• The crucible halves must close/seal
on the bottom (*) and leave a gap
between 1.5 to 3 mm at the top.
• Do not use damaged crucible
halves.
• CoCr / NiCr only: do not use crucible
halves with alloy residue on the bot-
tom.
NOTICE
Alloy residues can be easily removed if a drop of
water is added while they are hot.

Bego Nautilus T Specifications

General

Brand	Bego
Model	Nautilus T
Category	Dental equipment
Language	English