Bego Nautilus T - Mould Preparation and Placement; Mould Handling and Positioning Guidelines

English ⋅ Nautilus
®
CC plus ⋅ Nautilus
®
T
27
86105 BA-en/00
en
Basic principles: Moulds
Select suitable mould holders (see scope of
delivery) so that the moulds are positioned as high
as possible.
Mould holders
Align the mould so that the casting funnel is
positioned in the center of the "cross hairs".
WARNING
Burn hazard from hot surfaces!
• Always use mould tongs to move
moulds and mould holders.
• Wear suitable protective equipment
when operating the device!
CAUTION
Mould temperatures above 1050°C
may cause the device to overheat.
Never use damaged or cracked
moulds.