Behringer FCB1010 Using

Using a Behringer FCB1010 with a Korg Pa2X
38
Connect the FCB1010 and the RD-700GX to the Pa2X
Connect the MIDI OUT of the Roland RD-700GX to the MIDI IN of the FCB1010.
Connect the MIDI OUT/THRU of the FCB1010 to the MIDI IN of the Korg Pa2X.
Very Important!!!
Turn on the FCB1010 device first.
Then turn on the Roland RD-700GX.
Turn on the Pa2X last.
If you turn on the RD-700GX before turning on the FCB1010 unit, you will see a flashing LED.
The 10 Presets on Bank 1 is all you really need to remotely control the Korg Pa2X.
Pressing Fill 2 will move to the higher variation.
Pressing Fill 1 will move to the lower variation.
Pedals 6, 7, 8 and 9 will call the 4 STS settings.
You can change the Chords from your RD-700GX by playing fingered chords below the F3# split
point.
Expression Pedal A will control the modulation on the Pa2X voices
Expression Pedal B will control the expression on the Pa2X voices.

Behringer FCB1010 Specifications

General

Type	Controller
Proper use	Concert/Studio
Product color	Black, Grey

Weight and Dimensions

Depth	687 mm
Width	221 mm
Height	60 mm
Weight	4340 g