Behringer FCB1010 - Roland RD-700 GX Setup

Using a Behringer FCB1010 with a Korg Pa2X
36
Roland RD-700GX Setup
Create a SETUP as follows:
Turn on SPLIT. Hold down for the SPLIT button for 2 seconds.
Set Split Point = F#3
This will reflect the Split Point Setting of G3 on the Pa2X
You can layer 2 voices on the Upper Keyboard.
You can layer 2 voices on the Lower Keyboard.
Make sure the 2 Red Buttons and the 2 Green Buttons are turned on.
You can adjust the relative volumes of the 4 voices using the sliders.