38 39Quick Start Guide
GRIND
Clock Type Modes:
1. INTERNAL
2. MIDI DIN
3. MIDI USB
4. EXTERNAL TRIGGER
5. AUTO (clock priority: TRIG > MIDI USB > MIDI
DIN > INTERNAL)
Clock Edge Modes:
1. Fall
2. Rise
The parameters may be changed using the
following procedure:
1. Press SHIFT+ HOLD/REST + 8 to enter the setting
mode. The LOCATION LED 1 will blink yellow.
2. Press <KYBD or STEP> to select pages 1
to 4. The yellow LOCATION LED shows the
current page:
3. Page 1 allows you to select the tempo input
mode, 1 to 5. (Please see Programming Tempo
Input Modes, below)
4. Page 2 allows you to select the assign output
mode, 1 to 16. (Please see Assignable Output
Mode, below)
5. Page 3 allows you to select the clock type
mode, 1 to 5. (Please see Clock Type Modes,
below)
6. Page 4 allows you to select the clock edge mode,
1 to 2. (Please see Clock Edge Modes, below)
7. Press STEP switches 1 to 8 to select numeric
values from 1 to 8. The current value is
indicated by a green LOCATION LED.
8. To access values 9 to 16, press SHIFT + STEP
switch 1 to 8. The current value is shown by a
red LOCATION LED.
9. Note: If a setting is on the same LED number as
the current page LED, then the LED will ash
alternately between the yellow page color
and the green or red parameter color.
10. Press SHIFT + HOLD/REST + 8 to exit the
setting mode, and save any parameter
changes.
11. More parameters can be changed using the
SynthTribe App.
Programming Tempo Input Modes:
1. 1PPS
2. 2PPQ
3. 24PPQN
4. 48PPQN
5. CV
Assignable Output Modes:
1. Sequencer Accent
2. Sequencer Clock
3. Sequencer Clock/2
4. Sequencer Clock/4
5. Sequencer Step Ramp
6. Sequencer Step Saw
7. Sequencer Step Triangle
8. Sequencer Step Random
9. Sequencer Step 1 Trigger Output
10. MIDI Velocity
11. MIDI Channel Pressure
12. MIDI Pitch Bend
13. MIDI CC1
14. MIDI CC2
15. MIDI CC4
16. MIDI CC7
GRIND Parameter Selection Mode
To Next Page
Loading...
