Behringer WASP DELUXE - Procedure

Value
0
Value (hex) MIDI Transpose
0 -12
1 1 -11
2 2 -10
3 3 -9
4 4 -8
5 5 -7
6 6 -6
7 7 -5
8 8 -4
9 9 -3
10 A -2
11 B -1
12 C 0
13 D 1
14 E 2
15 F 3
16 10 4
17 11 5
18 12 6
19 13 7
20 14 8
21 15 9
22 16 10
23 17 11
24 18 12
WASP DELUXE Eurorack Installation
The WASP DELUXE synthesizer can be removed from its factory chassis and installed into a standard Eurorack chassis (not supplied). The module width is 70HP.
We recommend that this procedure is undertaken only by experienced service technicians, to prevent personal injury or damage to the unit.
The Eurorack case will need its own suitable power supply unit to power the WASP DELUXE synthesizer.
A 10-pin connector on the rear of the main PCB of the WASP DELUXE allows the +12 VDC power supply connection to be made. A 10-pin to 16-pin adapter ribbon cable is
supplied to connect to your power supply.
Before proceeding, make sure that your power supply is capable of supplying +12 VDC, 1 Amp.
Make sure that the connections using the supplied adapter cable will supply the ground and power to the correct pins of X23.
Procedure
Follow all steps in the order in which they are presented.
1. Disconnect the power cord and all other connections to the WASP DELUXE.
2. Undo the 8 screws on the top panel as shown. There is no need to undo any other screws.
3. Disconnect the two cables from the lower side of the main PCB of the WASP DELUXE, and remove the assembly from the chassis. ,
4. Store the chassis assembly and the power supply the adaptor in a dry safe place.
5. Securely connect the 10-pin end P1 of the supplied adapter cable to connector X23 on the Main PCB of the WASP DELUXE.