6. Make sure your power supply is turned off and disconnected from the AC mains.
7. Make sure that your power supply will supply the following to the pins of connector X23, as shown in the diagram above:
Pins Connection
1 and 2 No Connection
3 to 8 Ground
9 and 10 +12 VDC
8. Securely connect the 16-pin end P2 of the supplied adapter cable to your power supply, and double-check all connections are correct.
9. Securely install the WASP DELUXE Synthesizer into your Eurorack, using 8 screws in the front panel.
10. Perform a full test and safety test before using the
WASP DELUXE.
11. The 3.5 mm MAIN OUT connector on the top panel is used instead of the .” rear outputs which are no longer present.
Setting the MIDI Channel
Once installed in a Eurorack, the MIDI channel number is automatically set to channel 1 (as the MIDI switches are no longer present.)
The MIDI channel can be changed using MIDI-OX or a similar MIDI utility on your computer to send MIDI SysEx commands directly to the WASP DELUXE via the USB MIDI
connection. Here is a brief guide to the procedure (see the MIDI SysEx pages in this manual for the actual SysEx codes sent to the WASP DELUXE):
1. Disable the MIDI Channel Switches by sending the appropriate SysEx command.
2. Change the MIDI Channel by sending the appropriate SysEx command.
Specifications
To Next Page
Loading...
