EasyManua.ls Logo

Beko WTX71231W - User Manual

Beko WTX71231W
56 pages
Go to English
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
2820525916_IT / 08-06-17.(20:57)
Lavatrice
Manuale utente
WTX71231W
IT / EN
Numero del documento=
Washing Machine
User’s Manual

Table of Contents

Questions and Answers

  • I
    iharrisAug 14, 2025
    What to do if the loading door of my Beko WTX71231W cannot be opened?
    • J
      jeremy13Aug 14, 2025
      If the loading door of your Beko Washer won't open, it could be due to several reasons. The door lock might be activated because of the water level; drain the water by running the Pump or Spin programme. The machine may be heating water or in the spinning cycle; wait until the programme completes. If the child lock is engaged, wait a couple of minutes after the programme ends for deactivation. The door may also be stuck due to pressure; try pushing and pulling the door to release it.
  • Z
    zsloanAug 18, 2025
    Why is my Beko WTX71231W Washer not draining water?
    • S
      Samantha SmithAug 18, 2025
      If your Beko Washer isn't draining water, the water drain hose might be clogged or twisted; clean or flatten the hose. Alternatively, the pump filter could be clogged; clean the pump filter.
  • O
    Olivia Kirk MDAug 21, 2025
    Why does my Beko WTX71231W Washer enter standby mode or not take in water?
    • B
      Brenda RobersonAug 21, 2025
      If your Beko Washer enters standby mode or doesn't take in water, check the following: ensure the tap is turned on, the water inlet hose is not bent, and the water inlet filter is not clogged. Also, make sure the loading door is closed properly. Finally, verify the water connection and ensure water is not cut off. If it was cut off, press the Start/Pause key after the water has been supplied again.
  • A
    Amber FloresAug 25, 2025
    How to stop my Beko Washer from vibrating and making noise?
    • A
      ann95Aug 25, 2025
      If your Beko Washer is vibrating or making noise, several factors could be the cause. First, ensure the machine is standing balanced by adjusting the feet to level it. Check for any hard substances in the pump filter and clean it if necessary. Make sure the transportation safety bolts have been removed. The laundry quantity might be too little or too much; adjust the load accordingly. Also, verify that the machine isn't leaning on anything rigid.
  • C
    Carla BakerAug 28, 2025
    Why is my Beko Washer taking longer than expected?
    • S
      Stephen GarciaAug 28, 2025
      Several factors can cause your Beko Washer to take longer than the time specified in the manual. Low water pressure can cause the machine to wait until it takes in an adequate amount of water. Low voltage or a low input water temperature can also extend washing time. The machine may also increase the amount of rinse water or add an extra rinsing step. Excessive foam due to too much detergent usage can also activate the automatic foam absorption system, prolonging the wash.
  • M
    maria33Aug 31, 2025
    Why is there too much foam in my Beko WTX71231W?
    • L
      Laura HernandezAug 31, 2025
      Too much foam in your Beko Washer can be caused by using improper detergents, using an excessive amount of detergent, or storing detergent under improper conditions. Some meshed laundry items may also create excessive foam. In rare cases, the softener may be dispensed early due to a problem in the valves or detergent dispenser.
  • S
    Stephanie BlackSep 3, 2025
    Why is the laundry turning gray after washing in my Beko WTX71231W Washer?
    • L
      lisalandrySep 3, 2025
      Laundry turning gray after washing in your Beko Washer can result from several issues: using insufficient detergent over time, washing at low temperatures for too long, using insufficient detergent with hard water, or using too much detergent. Overloading the machine, selecting the wrong programme and temperature, or using the wrong type of detergent can also contribute to this problem.
  • C
    Cory RomeroSep 7, 2025
    Why is foam overflowing from the detergent drawer of my Beko WTX71231W?
    • T
      Tara KnappSep 7, 2025
      Foam overflowing from the detergent drawer of your Beko Washer is often caused by using too much detergent. To resolve this, mix 1 tablespoonful of softener with ½ liter of water and pour it into the main wash compartment of the detergent drawer. Also, ensure you are using the correct amount of detergent for the selected programme and load size, and reduce the amount of detergent when using additional chemicals like stain removers or bleach.
  • D
    Dana JordanSep 10, 2025
    Why do my clothes smell unpleasant after washing in my Beko WTX71231W Washer?
    • E
      Evelyn FrancisSep 12, 2025
      If your clothes smell unpleasant after washing in your Beko Washer, it could be due to odours and bacteria forming on the drum from continuous washing at lower temperatures and/or in short programmes. To prevent this, leave the detergent drawer and the loading door ajar after each washing to avoid a humid environment that encourages bacteria growth.

Beko WTX71231W Specifications

General IconGeneral
TypeFreestanding
Capacity7 kg
Spin Speed1200 RPM
Energy Efficiency ClassA+++
Programs15
Noise Level (Spinning)76 dB
ColorWhite

Related product manuals