What to do if my Beko WTXS51022W does not drain water?
If your Beko Washer isn't draining water, the water drain hose might be clogged or twisted, so you should clean or flatten the hose. Also, the pump filter might be clogged, so you should clean the pump filter.
Why can't I open the loading door of my Beko Washer?
If your Beko Washer loading door cannot be opened, it might be due to a few reasons. The door lock may be activated because of the water level in the machine; drain the water by running the Pump or Spin program. The machine might be heating up water or is at the spinning cycle; wait until the program completes. If the child lock is engaged, wait a couple of minutes for deactivation of the door lock. The loading door may be stuck because of the pressure it is subjected to, grab the handle and push and pull the loading door to release and open it.
Why does my Beko WTXS51022W not rinse well?
If your Beko Washer isn't rinsing well, the amount, brand, and storage conditions of the detergent used may be inappropriate, so use a detergent appropriate for the washing machine and your laundry and keep detergents closed in a humidity-free environment. The detergent might be put in the wrong compartment, so put the detergent in the correct compartment. The pump filter might be clogged, so check the filter. The drain hose might be folded, so check the drain hose.
What to do if my Beko Washer enters standby mode or doesn't take in water?
If your Beko Washer enters standby mode or doesn't take in water, check if the tap is turned on and turn it on if it's off. Ensure the water inlet hose isn't bent and flatten it if it is. Clean the water inlet filter if it's clogged. Make sure the loading door is closed properly. Finally, check the water connection; if the water is cut off, press the Start/Pause key after the water has been supplied again to resume the operation from standby mode.
Why is my Beko WTXS51022W vibrating and making noise?
If your Beko Washer vibrates or makes noise, it could be due to several reasons. First, make sure the machine is standing balanced by adjusting the feet. Another cause could be that the transportation safety bolts are still in place and need to be removed. Also, check if a hard substance has entered the pump filter and clean it if necessary. The laundry quantity might be too little or too much, so adjust the load accordingly. Finally, ensure the machine isn't leaning on anything.
Why does my Beko Washer take longer than usual?
If your Beko Washer takes longer than specified in the manual, it could be due to low water pressure. The machine waits until it takes in an adequate amount of water to prevent poor washing quality, therefore extending the washing time. Low voltage or low input water temperature can also prolong the washing time. The number of rinses or the amount of rinse water might have increased. Excessive foam might have occurred, activating the automatic foam absorption system due to too much detergent usage; use the recommended amount of detergent.
Why is the washing performance of my Beko WTXS51022W poor, and the laundry turns gray?
If your Beko Washer washing performance is poor and laundry turns gray, it could be due to insufficient detergent used over a long period, so use the recommended amount of detergent. Washing at low temperatures for a long time can also cause this, so select the proper temperature. Using insufficient detergent with hard water can cause soil to stick to the cloth. Too much detergent can also be a factor, so use the recommended amount. Avoid excessive laundry loads and select the proper program and temperature. Finally, ensure you are using the correct type of detergent.
Why does my Beko WTXS51022W Washer directly discharge the water it takes in?
If your Beko Washer is directly discharging the water it takes in, the draining hose might not be at an adequate height. Connect the water draining hose as described in the operation manual.
Why is the washing performance of my Beko Washer poor, and clothes smell unpleasantly?
If your Beko Washer washing performance is poor and clothes smell unpleasantly, odours and bacteria layers are formed on the drum as a result of continuous washing at lower temperatures and/or in short programmes. Leave the detergent drawer as well as the loading door of the machine ajar after each washing to prevent a humid environment favorable for bacteria.
Why did the colour of the clothes fade after washing in my Beko Washer?
If the colour of clothes faded after washing in your Beko Washer, it could be due to excessive laundry being loaded, so do not load the machine in excess. The detergent in use might be damp, so keep detergents closed in an environment free of humidity and do not expose them to excessive temperatures. A higher temperature might have been selected, so select the proper programme and temperature according to the type and soiling degree of the laundry.
General| Type | Freestanding |
|---|---|
| Capacity | 5 kg |
| Spin Speed | 1000 rpm |
| Energy Efficiency Class | A+++ |
| Spin Drying Class | C |
| Noise Level (Spinning) | 76 dB |
| Programs | 15 |
| Noise Level (Washing) | 58 dB |
To Next Page
