To Next PageTo Next PageWhat to do if my Beko WTXS61232WI does not drain water?
If your Beko Washer isn't draining water, it could be due to a clogged or twisted water drain hose. Try cleaning or flattening the hose. Alternatively, the pump filter might be clogged, so cleaning the pump filter may solve the problem.
How to open the loading door of my Beko WTXS61232WI Washer?
If you can't open the loading door of your Beko Washer, it might be due to a few reasons: 1. The door lock is activated because of the water level in the machine. Drain the water by running the Pump or Spin programme. 2. The machine is heating up the water or it is at the spinning cycle. Wait until the programme completes. 3. The child lock is engaged. Wait a couple of minutes for deactivation of the door lock. 4. The loading door may be stuck because of the pressure it is subjected to. Grab the handle and push and pull the loading door to release and open it.
Why won't my Beko Washer switch to the spinning step?
If your Beko Washer isn't switching to the spinning step, it could be due to an unbalanced load in the machine. The automatic unbalanced load detection system might be activated because of the laundry distribution in the drum. Also, the machine will not spin if water is not drained completely, so check the filter and the draining hose. Excessive foam might have occurred, activating the automatic foam absorption system due to too much detergent usage; therefore, use the recommended amount of detergent.
Why is my Beko WTXS61232WI Washer leaking water from the bottom?
If you notice water leaking from the bottom of your Beko Washer, the water drain hose might be clogged or twisted. Clean or flatten the hose. Additionally, the pump filter could be clogged, so cleaning the pump filter is advisable.
Why does my Beko Washer not rinse well?
If your Beko Washer doesn't rinse well, the amount, brand, and storage conditions of the detergent used may be inappropriate. Use a detergent appropriate for the washing machine and your laundry. Keep detergents closed in an environment free of humidity and do not expose them to excessive temperatures. Also, check if the detergent is put in the wrong compartment: If detergent is put in the prewash compartment although prewash cycle is not selected, machine can take this detergent during rinsing or softener step. Put the detergent in the correct compartment. Check the filter and the drain hose, as they might be clogged or folded.
Why does my Beko WTXS61232WI Washer enter standby mode or not take in water?
If your Beko Washer enters standby mode or doesn't take in water, check the following: * Ensure the tap is turned on. * Make sure the water inlet hose is not bent; flatten it if it is. * Clean the water inlet filter if it's clogged. * Ensure the loading door is closed properly. * Check the water connection and ensure water is not cut off. If it was cut off, press the Start/Pause key after the water supply resumes.
Why does my Beko WTXS61232WI Washer discharge water immediately?
If your Beko Washer is immediately discharging the water it takes in, the draining hose might not be at an adequate height. Connect the water draining hose as described in the operation manual.
Why did my Beko WTXS61232WI Washer stop shortly after starting?
If your Beko Washer stopped shortly after the programme started, it might have stopped temporarily due to low voltage. It will resume running when the voltage restores to the normal level.
What to do if the Beko Washer program does not start?
If the program on your Beko Washer doesn't start after closing the door, ensure that you have pressed the Start / Pause / Cancel button. Also, if the loading door is difficult to close due to excessive loading, reduce the amount of laundry and ensure the door is closed properly.
What to do if the Beko WTXS61232WI programme cannot be started or selected?
If a programme cannot be started or selected on your Beko Washer, the washing machine may have switched to self-protection mode due to a supply problem (line voltage, water pressure, etc.). To cancel the current programme, turn the Programme Selection knob to select another programme. The previous programme will be canceled.
General| Type | Front Load |
|---|---|
| Capacity | 6 kg |
| Spin Speed | 1200 rpm |
| Energy Efficiency Class | A+++ |
| Dimensions (H x W x D) | 84 x 60 x 54 cm |
| Programs | 15 |
| Color | White |
| Noise Level (Washing) | 58 dB |
| Noise Level (Spinning) | 76 dB |
