BELARUS-920.4/952.4 Operating manual
19
It is allowed to enter one non-specified value within the range:
for «Z» - from 23 to 69;
for «I» - from 1.000 to 4.000;
for «R» - from 400 to 1000;
for «K» - from 2.360 to 4.000; (For ID without CAN-interface)
for «KV2» - from 0.346 to 0.600;
for «ZV» - from 12 to 78;
for «V» - from 0 to 600.
List of programmed coefficients (graphic examples of displaying parameters and their values in
programming mode):
Parameter “Z”
Z – number of gear teeth of final shafts of driving wheels (right and left),
above which speed sensor (sender) are installed;
Parameter “I”
I – raising ratio correction factor of wheel-hub drive;
Parameter “ R”
R – rear wheel rolling radius, mm. In case of reprogramming it is possible
to change this parameter with 5 mm increment.
Note: 770 is the value for tires 18.4R34. In case of new types of tires set
the parameter "R” value which corresponds to rolling radius of installed
tires.
Parameter “ KV2”
KV2 – power take-off shaft (PTO) ratio;
Parameter “ZV”
ZV – number of gear teeth of PTO speed sender
(Note – if the sender is not installed, “0” value should be entered)
Parameter “V”
V – fuel tank volume, l.
Also in programming mode when pressing on “Parameter” button in the
list of programmed parameters independent parameter “T” of refined con-
tent of astronomical engine operating time meter is displayed. This param-
eter can not be changed, it gives precise value (up to 1/10 hour) of engine
operating time.
https://tractormanualz.com/
To Next Page
Loading...
