14
MIPP
Release
01
01/12
2 Device installation
The device has been developed for practical application in a harsh industrial
environment. Accordingly, the installation process has been kept simple.
The following sequence has proven itself in practice during installation:
Unpack delivery and inspect
Assemble the modules
Remove pre-installed modules from the housing
Install the installation cable on the modules
Mount modules in the housing
Mount device on the DIN rail or wall mounting plate
Connect the patch cable
2.1 Unpacking and checking
Before you start assembly, inspect the delivered goods for the following
points:
Do the goods match your order?
Are the individual parts undamaged?
Is the delivery complete (see page 22 “Scope of delivery”)?
2.2 Installing modules
You will receive the device with modules preinstalled according to your order.
You will require the following tools (not included in the delivery):
1 Cross-tip screwdriver
1 Strip tool
1 Splicer (with OF cables)
Note: Observe the minimum bend radius provided by the cable
manufacturer.
To Next Page
Loading...
