18
longer present. When the signal “ drop out” the radio will remain on the
channel momentarily before scan resumes. The delay time is programmed 500
to 10000 milliseconds.
●Talkback : When a signal is detected on a channel, scan pauses on that
channel, press PTT key can talk back on the channel if enable “Talk Back’
feature; if “Talk Back” isn’t checked, press PTT key may talk back on the
designated channel.
●First Priority Channel: Select first priority channel from scan list of members
channel. To begin scanning, the radio will automatically change to the first
priority channel then detect other channel on the scanning sequence. You can
set selected or a desired channel as first priority channel.
●Second Priority Channel: Select second priority channel from scan list of
members channel. To begin scanning, the radio will automatically change to
the first priority channel, then the second channel, at last detect other channel
on the scanning sequence. You can set selected or a desired channel as
second priority channel other than the first priority channel.
●TX Designated Channel : During scanning, Press PTT key will transmit on
TX designated channel. You can set TX Designated Channel as Last Active
Channel, Selected channel or a desired channel from scan list.
To Next Page
Loading...
