22
radio located at a close place please select Low power to save battery. Press
the programmed High/Low Power key to switch between high power and low
power. Switch to high power, a “high power” sounds; switch to low power, a
“low power” sounds.
Press programmed High/Low power key to switch power level or select power
level via programming software
Via programmable software to set it: Channel folder → Zone → a digital or analog
channel
→ TX Parameters → Power Level
Bandwidth
On analog mode, there are two types of bandwidth available, you can choose
bandwidth as wide (25 KHz) or narrow (12.5 kHz) via programming software.
Via programmable software to set it: Channel folder → Zone → An analog
channel
→Bandwidth
Squelch Level
On analog mode and digital mode compatible channel, this feature allows you
to adjust the squelch threshold for the radio to receive audio. You can set
squelch level as 0~9. High level requires stronger signal for the radio to
un-mute.
Via programmable software to set it: Channel folder → Zone → an analog
channel →Squelch Level
To Next Page
Loading...
