Using Your Router
Auto Update on Your Belkin Router
The router will automatically check for a newer version of firmware every time you log into the dashboard
and alert you with a message at the top of the screen if there is an update available. You can choose to
download the new version or ignore it.
You will see a series of prompts warning you that the firmware is about to be updated. Please do not
disconnect the power from the router at this time as it could cause the system to fail.
Updating the Router’s Firmware via the Web Interface
The following steps show you how to update your router’s firmware using its web interface. You do not
need to be connected to the Internet as this interface is built into the router itself.
Setup steps:
1.
Locate and download the firmware file from the Belkin support site. (Type your part number into
the search box in the top right corner and look for “Firmware” in the title.)
2.
Save the file to a location on your computer where you can get to it easily, such as your
desktop.
3.
Connect the computer to one of the four LAN ports on the router (refer to image).
4.
Open a web browser on the computer.
28
To Next Page
Loading...
Need help?
General
