K) MAIN OVEN LIGHT FITTING
FOLLOW STEP 7 (PAGE 7) REMOVING
REAR SERVICE PANEL
REMOVE GLASS LAMP COVER BY
UNSCREWING
REMOVE THE EARTH LEAD
RELEASE 4 XCLIPS HOLDING LIGHT
FITTING IN PLACE
REMOVE BY PULLING LIGHT FITTING
FORWARD INTO CAVITY
L) IGNITION GENERATOR
REMOVE 2 X EARTHING SCREWS
RELEASE IGNITION GENERATOR BY
PUSHING IN CLIPS ON R/H SIDE OF
GENERATOR AS SHOWN
REMOVE THE GENERATOR BY
PULLING AWAY FROM REAR SERVICE
PANEL
To Next Page
Loading...
