Belling platinum db3A - Troubleshooting Your Cooker; Fault Finding Guide

34
Is There Something Wrong With Your Cooker?
Fault Finding Guide Before contacting your Belling Service Center/Installer, check the problem
guide below; there may be nothing wrong with your cooker.
Problem Check
Nothing Works. Is the main cooker wall switch turned on?
Is the timer working? If the timer is not working it is
likely that there is no electricity supply to your cooker.
Large oven does not work.
Small oven working OK!
Ensure timer is set to manual.
(Refer to ‘Timer Instructions’ pages 14-18 )
Ensure the multifunction control is set to the required
position.
Ignition failure If all burners fail to ignite, check that sparks appear at
the burners, a clicking noise should be heard. If not
first check that:
• The electricity supply is turned on.
• The mains cooker switch on the wall is in the ON
position.
If only a hotplate burner is failing to light check that:
• The burner cap and ring are fitted correctly.
•
The holes in the burner ring are not blocked.
• The five hotplates may be lit with a match in the
event of ignition failure or power cut to the
electricity supply.
The flames of any of the hotplate burners appear to be
floating, have very yellow tips or are emitting an
objectionable odour.
The appliance is not working correctly and may be
operating dangerously. Switch off the hob burners
immediately and check that the burners and fittings are
fitted correctly. If the symptoms persist, then contact
your service engineer. Refer to the “SERVICE” section
in this instruction book.
DO NOT USE THE HOB!