If the appliance does not work
If the appliance does not operate check whether:
·The power supply is on.
·The
fuse has blown/circuit breaker has tripped/main distribution switch has been turned off.
• The control has been set correctly.
• Oven programmer has been reset.
If the appliance is still not operating after the above checks, please refer to the section on how to obtain
service.
Please ensure that the above checks have been made as a charge will be
mad_e
if no fault is found.
Performance characteristics when
in
use
•
When
using
your appliance
for
the
first
few
times,
an
odour and/or
smoke
may
be
emitted
which
is
norma
• It is normal for the metal parts to produce noise when
in
use, this is due to expansion and contraction.
• When in use, steam may be produced which
is normal and not a fault of the appliance.
·At
the end
of
a cooking session, it is normal to have a momentary puff of steam when the oven door is
opened. This should disperse
in
a few seconds.
• If, whilst cooking, steam produced comes in
to
contact with cool surface's on the outside of the appliance, it will condense and produce water droplets.
This
is
quite normal and is not a fault.
Keep the original carton and other packaging material in a safe place. Transport the appliance in its original
carton. Follow the instructions that are printed on the carton.
To
prevent the accessories inside the oven from damaging the oven door, tape a strip of cardboard onto
the inside
of
the oven door that lines up with the position of the trays. Tape the oven door to the side walls.
If you do not have the original carton
Take the necessary precautions
in
order
to
prevent the exterior panels, and the glass surfaces
of
the oven
from being damaged.
Pack the oven
in
bubble wrap or thick cardboard and tape it securely in order to prevent damage during
transportation.
Tt:!e
oven must be transported upright. Do not place other items on the top of the appliance.
Ensure that the appliance
is
switched off before replacing the lamp to avoid the
possibility of electric shock.
1. Switch off at the mains.
2. Remove the protective glass cover of the lamp inside your oven by turning it anti-clockwise.
3. Remove the bulb by turning it anti-clockwise.
4. After installing the correct replacement bulb, reinstall the protective glass of the lamp. Replacement
light bulb can easily
be
obtained from a good local electrical or DIY store.
21
To Next Page
Loading...
