Reference Manual
BLR-CX-R / BLR-CX-T
In case of an alarm will flash alternately at BLR-CX with "ALARM" an error code in the display.
The table below gives an overview of all possible error codes.
To reset pending alarms hold the (esc) button pressed for 5 seconds.
measured voltage is outside the set tolerance
measured current is less than 15mA (check the short
circuit bridge K and L and the entire current path
measured current is to high
The controller cannot achieve the target COS φ
The set limit for the THD of the voltage is exceeded
One or more steps are broken. The defective step is
blinking with the alarm message.
One or more step's have fallen below 70% of initial
power. step number and error code will flash alternately.
For devices with software version before 1.04 the alarm
is triggered at 50% of initial power.
The second temperature limit is exceeded. Stage were
switched off successively.
Set limit of operation hours has been exceeded
Set limit of the max. allowable operation cycles, for one
or more steps, has been exceeded.
Abort of auto-initialization.
To Next Page
Loading...
Need help?
General
