4 OPERATION
4.1 Keys
Increase values, select menu items
Escape menu,
move cursor left, Enter menu,
push 3 sec to clear move cursor right,
alarms confirmation of settings
Decrease values, select menu items
4.2 Input of numerical values
Whenever the BLR CX prompts for the input of a value, the routine will be the same:
A preset-value will be displayed with the first (highest) digit blinking. This digit can now be
changed by use of the and keys. Use the button to change to the next smaller digit.
After changing, the next digit will be also blinking and can now be altered just like the first
one. When arriving the last digit, press the key once more. This position allows to set
multipliers M (Mega) or k (kilo). To store the value, press the key once more, and the new
value will be saved and used.
In case, that an adjusted value cannot be stored respectively another value is shown after
confirmation with button, it’s possible that the adjusted value is outside of the allowed
range. For further information’s about possible ranges, please check the table on the last page.
At any time, one can go back to the menu he came from without changing the value by
pressing the key. In this case, the modified value will not be used!
To Next Page
Loading...
Need help?
General
