LC8810 User Manual V1.0
14
9. Connect power cord to the power adapter and plug the power cord into AC
power outlet. (The power adapter must be connected to the LC8810 f i r s t
before it is connected to AC power outlet. Do not connect AC power before
connecting to LC8810).
10. By default, the unit is set to turn on power automatically when power is
connected. If it does not power up, press the on/off switch on the front panel
to turn on power and check for correct CMOS configuration settings.
11. If the LC8810 had been shutdown from the operating system, it may be
restarted by pressing the power on/off switch on the front panel of the
LC8810. To turn off power to the unit, press and hold the power on/off switch
for 5 seconds.
To Next Page
Loading...
General