benchmarkwireline.com
P. O. BOX 850
Fax: 281.342.4848
Phone: 281.342.6415
Simonton,Texas 77476
36220 FM 1093
AM5K User Manual Rev Q Oct 2007 Page 10 of 44
3.5.2 To install the deep grooved tension wheel, replace the standard shallow
grooved tension wheel with the deep grooved tension wheel. The load pin
does not need to be changed. To account for the decreased bend angle
of the cable, the Load Cell Angle value will need to be changed when
using this wheel (refer to page 11). The SDDP calibrate value should
remain at 3250.
Ensure that the slot in the bushing of the tension wheel is aligned with the
roll pin on the side of the frame. The roll pin is only installed on one side
of the frame and it needs to be inserted in the slot.
Also ensure that the grease hole in the tension wheel is installed on the
opposite side as the load pin amplifier.
DEEP GROOVED HIGH TENSION WHEEL
STANDARD SHALLOW GROOVED TENSION WHEEL
To Next Page
Loading...