benchmarkwireline.com
P. O. BOX 850
Fax: 281.342.4848
Phone: 281.342.6415
Simonton,Texas 77476
36220 FM 1093
AM5K User Manual Rev Q Oct 2007 Page 8 of 44
3.3 CABLE REMOVAL UNDER LOAD
3.4.1 If under load, the load will need to be removed from the device prior to
removing the retaining pin. A “C-clamp" or a nylon "ratchet strap" can be
used to remove the load.
3.4.2 Install a C-Clamp across the top and bottom frames as shown in the
drawing below. The ratchet strap can be installed in a similar way.
3.3.3 Tighten the C Clamp until the load is removed from the retaining pin.
Remove the retaining pin then loosen and remove the C Clamp.
To Next Page
Loading...