10
20V BRUSHLESS 7-1/4" CIRCULAR SAW
1265-002
•
•
• Do not slow or stop a blade with a piece of wood. Let the blade come to
rest naturally.
• If you are interrupted when operating the saw, complete the process and
• Periodically check that all nuts, bolts, and other fixings are properly tightened.
• Do not store materials or equipment above a machine in such a way that they
could fall into it.
• Never saw near combustible liquids or gases.
• Note the direction of rotation of the motor and the blade.
• Do not lock the movable guard in the open position and always ensure that it is
working properly, freely rotating and returning to fully cover the teeth of the blade.
• Do not use any abrasive wheel unless the machine is designed for that purpose.
• The tool must be used only for its prescribed purpose. Any use other than those
mentioned in this Manual will be considered a case of misuse. The user and not
the manufacturer shall be liable for any damage or injury resulting from such
cases of misuse.
• The manufacturer shall not be liable for any changes made to the tool nor for
any damage resulting from such changes.
LASER LIGHT SAFETY RULES
WARNING: Do not stare directly into the laser beam! A hazard may exist
if you deliberately stare into the beam.
Please observe all the following safety rules:
• Never aim the beam at any person or any object other than the workpiece.
• Always ensure that the laser beam is aimed at a sturdy workpiece that does not
have any reflective surfaces. Wood and rough coated surfaces are acceptable.
Bright shiny reflective sheet steel or similar materials are not suitable for laser
use because the reflective surface could direct the beam back at the operator.
•
carried out by the laser manufacturer or by an authorized agent.
•
the risk of someone inadvertently starring into the laser’s beam.
To Next Page
Loading...
